Microlife Aponorm Mobil Blood Pressure Monitor User Manual

The Microlife Aponorm Mobil is a clinically validated, portable blood pressure monitor designed for easy, accurate, and reliable blood pressure and pulse rate measurements at home or on the go. It features a large LCD display, one-touch operation, memory storage for multiple users, irregular heartbeat detection, and a comfortable cuff. Below are key sections for safety, features, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Main unit with LCD display, Arm Cuff with D-Ring, Air Tube, Battery compartment, START/STOP button, Memory button.

Safety Information

Read all instructions before use. For safe and accurate operation:

1. Do not use on infants, children, or persons unable to express their consent.
2. Consult your physician before use if you have arrhythmia, pre-eclampsia, or other circulatory disorders.
3. Do not use the monitor on an injured or sore arm.
4. Do not inflate the cuff when it is not wrapped around your arm.
5. Keep the device away from strong electromagnetic fields (e.g., mobile phones, microwave ovens).

WARNING! This device is for self-measurement only, not for medical diagnosis. Always consult a healthcare professional for interpretation of readings.

Package Contents

• Microlife Aponorm Mobil Blood Pressure Monitor (Main Unit)
• Arm Cuff with integrated air tube
• 4 x 1.5V AA batteries
• Instruction Manual (this document)
• Storage case (model dependent)

CAUTION! Inspect contents upon unpacking. Do not use if any part appears damaged.

Device Overview

Front Panel: LCD Display, START/STOP button, Memory (M) button.

Display Symbols:

• SYS / DIA: Systolic / Diastolic pressure (mmHg)
• Pulse Symbol: Heart rate (pulses per minute)
• Irregular Heartbeat Symbol (IHD): Flashes if irregularity is detected
• User Indicator (A/B): Shows which user's memory is active
• Battery Symbol: Indicates battery level
• Memory Symbol: Indicates memory recall mode

Side/Back: Battery compartment cover, Air tube connector.

First-Time Setup

Prepare the monitor for first use.

1. Insert Batteries: Open battery compartment on back. Insert 4 AA batteries observing correct polarity (+/-). Close cover.
2. Connect Cuff: Plug the cuff air tube firmly into the connector on the side of the monitor.
3. Set User (Optional): Press the Memory (M) button to select User A or User B for storing readings separately.
4. Date & Time (if applicable): Some models allow setting; refer to specific supplement.

Tip: Rest for 5 minutes before taking your first measurement. Avoid caffeine, exercise, and smoking for 30 minutes prior.

Taking a Measurement

For accurate results, follow these steps precisely.

1. Prepare: Sit comfortably on a chair with back support. Rest for 5 minutes. Place feet flat on the floor.
2. Apply Cuff: Bare your left arm (or arm as recommended by your doctor). Pass the end of the cuff through the D-Ring. Wrap the cuff snugly around your upper arm, 1-2 cm above the elbow. The air tube should run down the center of your inner arm.
3. Position: Rest your arm on a table so the cuff is at heart level. Relax your hand, palm up.
4. Measure: Press the START/STOP button. The cuff will inflate automatically. Remain still and quiet until measurement is complete and the cuff deflates.
5. Read Results: Your systolic pressure, diastolic pressure, and pulse rate will display. Note any flashing IHD symbol.
6. Power Off: The device turns off automatically after about 1 minute, or press START/STOP to turn off immediately.

WARNING! Do not move or talk during measurement. Ensure the cuff is at heart level for accuracy.

Memory Function

The monitor stores the last 30 readings for each user (User A and User B).

1. Select User: Before measurement, press the Memory (M) button to toggle between User A and User B. The corresponding letter will show on the display.
2. Recall Memory: With the device off, press and hold the Memory (M) button for 3 seconds. The display will show the average of the last 3 readings stored for the selected user. Press the M button repeatedly to scroll through individual stored readings (most recent first).
3. Clear Memory: To delete all readings for the currently selected user, enter memory recall mode, then press and hold both the START/STOP and Memory buttons simultaneously for 5 seconds until "CLr" appears.

Understanding Results

Refer to the classification chart below. Always discuss your readings with your doctor.

Irregular Heartbeat Symbol (IHD): If this symbol flashes during or after a measurement, it may indicate a pulse irregularity. Take a second measurement after a few minutes of rest. If the symbol appears frequently, inform your physician.

Care & Maintenance

Proper care ensures longevity and accuracy.

1. Cleaning: Wipe the monitor and cuff with a soft, slightly damp cloth. Do not immerse in water or use solvents.
2. Storage: Store in the provided case in a cool, dry place. Avoid extreme temperatures, humidity, dust, and direct sunlight.
3. Cuff Care: Do not fold the cuff tightly or twist the air tube. Remove the cuff from the monitor if storing for a long period.
4. Do Not: Disassemble the unit, subject it to strong shocks, or attempt repairs yourself.

CAUTION! Never wash or sterilize the cuff in an autoclave, dishwasher, or washing machine.

Battery Information

• Type: 4 x 1.5V AA alkaline batteries (LR6).
• Battery Life: Approximately 500 measurements (with alkaline batteries).
• Low Battery Indicator: The battery symbol on the display will flash or appear empty when batteries are low.
• Replacement: Replace all 4 batteries at the same time. Use high-quality alkaline batteries. Remove batteries if the device will not be used for several months.

WARNING! Do not use rechargeable (Ni-MH) batteries unless specified in the manual, as they may provide lower voltage and affect accuracy or function.

Troubleshooting

Reset: Remove batteries for 5 minutes, then reinsert. This may clear temporary errors.

Service: For technical support or service, contact Microlife customer service or visit www.microlife.com. Do not open the device.